红外光谱微量水平衰减全反射技术检验常见胶水的应用研究

目的建立无损快速检验胶水红外光谱法。方法利用红外光谱衰减全反射技术（ATR）对8种常见胶水样品进行光谱分析,根据出峰位置差异,对8种胶水样品进行鉴别,并建立相应的红外光谱数据库。结果不同类型的胶水其红外图谱有明显差异,而同一类胶水在某些波数区间也存在着一定的差异。结论利用红外光谱衰减全反射技术可以快速、准确、无损的检验鉴别胶水样品。     

二维红外光谱用于急性心肌缺血猝死的鉴别研究

目的采用衰减全反射-傅里叶变换红外光谱(ATR-FTIR)技术检测急性心肌缺血猝死大鼠的血清分子特征,探讨二维红外光谱鉴别急性心肌缺血猝死的法医学价值。方法成年雄性SD大鼠随机分为急性心肌缺血猝死组(实验组)和空气栓塞死组(对照组),血清样本行ATR-FTIR检测,应用OMNIC软件进行光谱预处理并求二阶导数光谱,分别计算两组原始光谱及二阶导数光谱的相似度,并应用Matlab R2010a软件建立二维光谱模型。结果实验组与对照组的大鼠血清的原始红外光谱在峰形、峰位、峰强度均极其相似,相似度达99.78%,二阶导数光谱显示出两者相似度降至98.62%,二维光谱模型显示两组光谱在1 625cm~(-1)、1 550cm~(-1)、1 080cm~(-1)及860cm~(-1)附近的成分差异,且它们的自动峰个数不相同,提示两组在蛋白质、糖原、核酸等分子含量存在较明显差异。结论仅从一维光谱上难以区分出两组的分子差异,二维红外光谱可以直观、有效地反映出急性心肌缺血猝死与空气栓塞死的大鼠血清分子差异,有望应用于法医学死因鉴别。     

傅里叶红外图像无损检验添改数字的研究

目的建立利用傅里叶红外图像系统无损检验添改数字的检验方法。方法采集同种同品牌、同种不同品牌及不同种书写材料书写的数字1改为4和3添加为8两类样本的红外图像，根据红外吸收的光谱信息对其添改进行检验。结果同种不同品牌及不同种书写材料对红外吸收强弱不同，形成的红外图像有差别；同种同品牌书写材料对红外吸收强弱没有明显差别。结论该检验方法不损坏检材，重现性好，并且纸张成分对其分析结果基本上无干扰。     

502胶控制湿度贴显法显现皮革面上手印

目的　研究皮革面上汗潜手印的显现。方法　通过对遗留在皮革面不同时间的指印采用常规熏显、自然贴附、控制湿度贴附三种方法进行处理并比较效果。结果　控制湿度贴附显现法在皮革面上显现的成功率高于效果明显常规熏显法和自然贴附法。结论　为皮革面上手印的显现提供了一种新的方法     

大鼠死后脑组织的傅里叶变换红外光谱变化

目的应用傅里叶变换红外（Fourier transform infrared．FTIR）光谱技术分析大鼠死后脑组织随死亡时间推移的化学变化过程,为死亡时间推断的研究提供新的途径与数据。方法大鼠断颈处死后置于（30±2）℃环境下,在不同时间点提取大鼠脑皮质．运用FTIR光谱仪检测不同化学基团的变化。结果随着死亡时间的推移,大鼠脑组织FTIR光谱的主要吸收峰峰位没有明显变化．而其峰强有明显差异：（1）与核酸有关的谱带的相对峰强呈明显下降趋势;（2）酰胺Ⅰ、Ⅱ的峰强比（I1647/I1541）呈下降趋势;（3）1456和1398cm^-1谱带的峰强各自呈下降和上升趋势;（4）2852、2871、2923和2958cm^-1谱带的峰强相对于1647cm^-1而言．呈上升趋势。结论脑组织可以作为FTIR光谱技术分析死亡时间的适用检材。     

Rapid detection of synthetic cannabinoid receptor agonists impregnated into paper by attenuated total reflectance Fourier transform infrared spectroscopy

The last few years have witnessed the change in the modalities of smuggling of synthetic cannabinoid receptor agonists (SCRAs) by impregnating them in mail envelopes and fast parcels. Considering the aforementioned scenario, it is important to develop a portable technique to identifying SCRAs through packages. The purpose of this research was to detect SCRAs impregnated into substrates of paper using attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectroscopy. Three SCRAs that included 5F-PB-22, AB-FUBINACA and AKB-48 were purchased from Sigma Aldrich. The three SCRAs and four cutting agents were impregnated into paper of variable thickness at four concentrations (10, 15, 20, and 25 mg/mL). Spectra were collected over the wavenumber range of 650–4000 cm⁻¹ using ATR-FTIR spectroscopy and were exported to Matlab 2020b where data analysis was applied. The FTIR spectral data was able to show the three SCRAs could be detected on paper using ATR-FTIR spectroscopy and quantitatively modeled using the partial least squares regression algorithm. Principal component analysis showed separate clustering for the compounds that crystallized (5F-PB-22, AB-FUBINACA and caffeine) onto the papers surface from those impregnated into the bulk of the paper (AKB-48 and procaine) with the latter situated near blank papers in score plots. In summary, ATR-FTIR spectroscopy has proven to be a successful non-destructive technique in detecting and quantifying a selection of SCRAs impregnated into paper.     

Identification and age estimation of blood stains on colored backgrounds by near infrared spectroscopy

Non-destructive identification and subsequent age estimation of blood stains are significant steps in forensic casework. The latter can provide important information on the temporal aspects of a crime. As previously shown, visible spectroscopy of blood stains on white backgrounds can successfully be used for their identification and age estimation. The use of this technique however, is hampered by dark backgrounds. In the present study the feasibility to use near infrared (NIR) spectroscopy was evaluated for blood stain identification and age estimation on dark backgrounds. Using NIR reflectance spectroscopy, blood stains were distinguished from other substances with 100% sensitivity and 100% specificity. In addition, Partial Least Squares Regression analysis was applied to estimate the age of blood stains on colored backgrounds. The age of blood stains up to 1 month old was estimated successfully with a root mean squared error of prediction of 8.9%. These findings are an important step toward the practical implementation of blood stain identification and age estimation in forensic casework, where a large variety of backgrounds can be encountered.     

Examination of lubricating oils by infrared spectroscopy

Approximately 60 oil samples obtained from the chassis of various motor cars have been examined by infrared spectroscopy. The samples were oils from the engine, gearbox and back-axle. Differences in absorbance of some absorption bands in the infrared spectra (IR) of oil samples were observed. An optimal set of absorption bands was chosen, which was used for quantitative comparison of slightly differing spectra. The significance of differences was tested using Hotelling's T²-test.     

An investigation of model forensic bone in soil environments studied using infrared spectroscopy

Infrared spectroscopy has been used to examine changes to bone chemistry as a result of soil burial. Pig carcasses were buried as part of a controlled field study, and pig bone was used in soil environments established in the laboratory. The variables of species type, bone pretreatment, soil type and pH, moisture content, temperature, and burial time were investigated. The crystallinity index (CI) and the organic and carbonate contents of the bones were monitored. The data revealed decreasing trends in the organic and carbonate contents and an increase in the CI of the bone with burial time. An acidic soil environment and soil type are the factors that have the most influence on bone chemistry as a result of burial. The study demonstrates the potential of infrared spectroscopy as a straightforward method of monitoring the changes associated with aging of bones in a variety of soil environments.     

傅立叶变换红外光谱法检验静电复印墨粉

目的　通过对静电复印墨粉进行检验 ,达到对不同厂家及不同型号墨粉区分的目的。方法　首先利用电熨斗加热提取复印件的墨粉 ,然后利用傅立叶变换红外光谱法对 9个墨粉厂家和 2 4种牌号进行检验。结果可以达到厂家区分和大部分牌号区分 ,区分率达到 95 .7%。结论　本研究对实际应用有较大参考价值。     

Passport examination by polarized infrared spectra

In this study, a new nondestructive technique for passport examination is proposed. In this technique, linearly polarized light is used to measure Fourier transform infrared (FT-IR) reflectance spectra of films on the biographical data page. Thirty genuine and thirty-five counterfeit Japanese passports and five marketed films pasted on name cards were examined. The measured spectra were analyzed as follows. The absorption spectra were obtained by the Kramers-Kronig transformations of reflectance spectra. The peak ratios were then calculated from the absorption spectra by adding the peak areas at 1126 and 1263 cm(-1) and dividing the result by the peak area at 1727 cm(-1). When nonpolarized light was used, the samples could not be distinguished by comparing the peak ratios. However, when polarized light was used, they were successfully distinguished by the comparison. Therefore, polarized light is useful for the forensic discrimination of passport films by the measurement of FT-IR spectra.