The Analysis of Colored Acrylic,Cotton, and Wool Textile Fibers Using Micro‐Raman Spectroscopy. Part 2: Comparison with the Traditional Methods of Fiber Examination

In the second part of this survey, the ability of micro‐Raman spectroscopy to discriminate 180 fiber samples of blue, black, and red cottons, wools, and acrylics was compared to that gathered with the traditional methods for the examination of textile fibers in a forensic context (including light microscopy methods, UV‐vis microspectrophotometry and thin‐layer chromatography). This study shows that the Raman technique plays a complementary and useful role to obtain further discriminations after the application of light microscopy methods and UV‐vis microspectrophotometry and assure the nondestructive nature of the analytical sequence. These additional discriminations were observed despite the lower discriminating powers of Raman data considered individually, compared to those of light microscopy and UV‐vis MSP. This study also confirms that an instrument equipped with several laser lines is necessary for an efficient use as applied to the examination of textile fibers in a forensic setting.     

Discrimination Between Infant and Adult Bloodstains Using Micro‐Raman Spectroscopy: A Preliminary Study

In the present study, we used micro‐Raman spectroscopy with high‐resolution analysis to discriminate between bloodstains from infants and bloodstains from adults. Raman peaks were detected at 674, 754, 976, 1002, 1105, 1127, 1176, 1248, 1340, 1368, 1390, 1560, and 1611 cm^?1; these peaks were derived from hemoglobin, albumin, and glucose. However, a peak was obtained at 1105 cm^?1, which was assigned to histidine; this peak was observed only for bloodstains from adults. Human adult hemoglobin (HbA) is composed of an α₂β₂ tetramer structure, whereas human fetal hemoglobin (HbF) is composed of an α₂γ₂. Therefore, the lack of a Raman peak at 1105 cm^?1 in bloodstains from infants indicates the possibility of two histidine substitutions (His116Ile and His143Ser) in the γ chain of HbF. This study discriminates between bloodstains from infants and bloodstains from adults using micro‐Raman spectroscopy, with beneficial implications in forensic science.     

Application of Raman Spectroscopy and Surface‐Enhanced Raman Scattering to the Analysis of Synthetic Dyes Found in Ballpoint Pen Inks*

Abstract: The applicability of Raman spectroscopy and surface‐enhanced Raman scattering (SERS) to the analysis of synthetic dyes commonly found in ballpoint inks was investigated in a comparative study. Spectra of 10 dyes were obtained using a dispersive system (633 nm, 785 nm lasers) and a Fourier transform system (1064 nm laser) under different analytical conditions (e.g., powdered pigments, solutions, thin layer chromatography [TLC] spots). While high fluorescence background and poor spectral quality often characterized the normal Raman spectra of the dyes studied, SERS was found to be generally helpful. Additionally, dye standards and a single ballpoint ink were developed on a TLC plate following a typical ink analysis procedure. SERS spectra were successfully collected directly from the TLC plate, thus demonstrating a possible forensic application for the technique.     

Real‐Time Detection of Concealed Chemical Hazards Under Ambient Light Conditions Using Raman Spectroscopy

Current concerns regarding terrorism and international crime highlight the need for new techniques for detecting unknown and hazardous substances. A novel Raman spectroscopy‐based technique, spatially offset Raman spectroscopy (SORS), was recently devised for noninvasively probing the contents of diffusely scattering and opaque containers. Here, we demonstrate a modified portable SORS sensor for detecting concealed substances in‐field under different background lighting conditions. Samples including explosive precursors, drugs, and an organophosphate insecticide (chemical warfare agent surrogate) were concealed inside diffusely scattering packaging including plastic, paper, and cloth. Measurements were carried out under incandescent and fluorescent light as well as under daylight to assess the suitability of the probe for different real‐life conditions. In each case, it was possible to identify the substances against their reference Raman spectra in less than 1 min. The developed sensor has potential for rapid detection of concealed hazardous substances in airports, mail distribution centers, and customs checkpoints.     

Infrared Spectra of U.S. Automobile Original Finishes (Post – 1989). VIII: In Situ Identification of Bismuth Vanadate Using Extended Range FT‐IR Spectroscopy,Raman Spectroscopy,and X‐Ray Fluorescence Spectrometry

Chrome Yellow (PbCrO₄·xPbSO₄) was a common pigment in U.S. automobile OEM finishes for more than three decades, but in the early 1990s its use was discontinued. One of its main replacements was Bismuth Vanadate (BiVO₄·nBi₂MoO₆, n = 0–2), which was commercially introduced in 1985, as this inorganic pigment also produces a very bright hue and has excellent outdoor durability. This paper describes the in situ identification of Bismuth Vanadate in automotive finishes using FT‐IR and dispersive Raman spectroscopy and XRF spectrometry. Some differentiation of commercial formulations of this pigment is possible based on far‐infrared absorptions, Raman data, and elemental analysis. The spectral differences arise from the presence or absence of molybdenum, the use of two crystal polymorphs of BiVO₄, and differences in pigment stabilizers. Bismuth Vanadate is usually not used alone, and it is typically found with Isoindoline Yellow, hydrous ferric oxide, rutile, Isoindolinone Yellow 3R, or various combinations of these.     

Identification of Different Forms of Cocaine and Substances Used in Adulteration Using Near‐infrared Raman Spectroscopy and Infrared Absorption Spectroscopy

Identification of cocaine and subsequent quantification immediately after seizure are problems for the police in developing countries such as Brazil. This work proposes a comparison between the Raman and FT‐IR techniques as methods to identify cocaine, the adulterants used to increase volume, and possible degradation products in samples seized by the police. Near‐infrared Raman spectra (785 nm excitation, 10 sec exposure time) and FT‐IR‐ATR spectra were obtained from different samples of street cocaine and some substances commonly used as adulterants. Freebase powder, hydrochloride powder, and crack rock can be distinguished by both Raman and FT‐IR spectroscopies, revealing differences in their chemical structure. Most of the samples showed characteristic peaks of degradation products such as benzoylecgonine and benzoic acid, and some presented evidence of adulteration with aluminum sulfate and sodium carbonate. Raman spectroscopy is better than FT‐IR for identifying benzoic acid and inorganic adulterants in cocaine.     

Analysis and Discrimination of Single‐Layer White Architectural Paint Samples,

Comparative analyses of 50 single‐layer white architectural paints were conducted to determine the discrimination power using standard techniques and to provide a basis for assessing significance when paints with limited features are not discriminated. Utilizing Fourier transform infrared spectroscopy (FTIR), 68 undifferentiated pairs resulted, yielding a discrimination of 94.45%. Adding stereomicroscopy, scanning electron microscopy (SEM) with energy dispersive spectroscopy (EDS) and backscatter electron (BSE) imaging, and pyrolysis‐gas chromatography/mass spectrometry (Py‐GC/MS), the overall discrimination was 99.35%. The study included blind verification replicates, which resulted in the only pairs without indications of physical or chemical differences. The remaining groups of undifferentiated samples contained subtle differences by at least one technique, but were considered undifferentiated for the discrimination power evaluations. This study demonstrates a high degree of discrimination of single‐layer white architectural paints using methods of analysis often encountered in forensic science laboratories.     

Elemental Characterization and Discrimination of Nontoxic Ammunition Using Scanning Electron Microscopy with Energy Dispersive X‐Ray Analysis and Principal Components Analysis

Concerns over the toxic by‐products produced by traditional ammunition have led to an increase in popularity of nontoxic ammunition. In this work, the chemical composition of six brands of nontoxic ammunition was investigated and compared to that of a road flare, which served as an environmental source with similar composition. Five rounds of each brand were fired while a further five were disassembled and the primer alone was fired. Particles collected from all samples, including the road flare, were analyzed by scanning electron microscopy with energy dispersive X‐ray analysis. Common elements among the different ammunition brands included aluminum, potassium, silicon, calcium, and strontium. Spectra were then subjected to principal components analysis in which association of the primer to the intact ammunition sample was generally possible, with distinction among brands and from the road flare sample. Further, PCA loadings plots indicated the elements responsible for the association and discrimination observed.     

The Reliability of Pattern Classification in Bloodstain Pattern Analysis,Part 1: Bloodstain Patterns on Rigid Non‐absorbent Surfaces

This study was designed to produce the first baseline measure of reliability in bloodstain pattern classification. A panel of experienced bloodstain pattern analysts examined over 400 spatter patterns on three rigid non‐absorbent surfaces. The patterns varied in spatter type and extent. A case summary accompanied each pattern that either contained neutral information, information to suggest the correct pattern (i.e., was positively biasing), or information to suggest an incorrect pattern (i.e., was negatively biasing). Across the variables under examination, 13% of classifications were erroneous. Generally speaking, where the pattern was more difficult to recognize (e.g., limited staining extent or a patterned substrate), analysts became more conservative in their judgment, opting to be inconclusive. Incorrect classifications increased as a function of the negatively biasing contextual information. The implications of the findings for practice are discussed.     

The Differentiation of Menstrual from Venous Blood and Other Body Fluids on Various Substrates Using ATR FT‐IR Spectroscopy

Crime scene investigators and laboratory analysts use chemical tests to detect and differentiate body fluids. Testing often requires a sample of the stain, and the chemicals may cause degradation of the fluid or interfere with subsequent tests. Colorimetric chemical tests do not differentiate between different types of the same fluid, such as venous and menstrual blood, and there is no presumptive test available to simultaneously differentiate several body fluids. In this study, we recorded ATR FT ‐IR spectra of venous and menstrual blood, semen, saliva, and breastmilk. Neat and simulated casework body fluid samples were analyzed on cotton, nylon, wood, paper, and glass substrates. Differences in fluid composition, including proteins and small molecules, resulted in spectral differences. Venous and menstrual blood is differentiated by the peak at 1039 cm^?1 attributed to phosphoric acid found in menstrual blood. Peak intensity is influenced by the porosity and weave of the substrate fabric.     

Characterization and Differentiation of Geometric Isomers of 3‐methylfentanyl Analogs by Gas Chromatography/Mass Spectrometry,Liquid Chromatography/Mass Spectrometry,and Nuclear Magnetic Resonance Spectroscopy

The cis and trans isomers of 3‐methylfentanyl and its three analogs were chemically synthesized, and these compounds were characterized and differentiated by gas chromatography/mass spectrometry (GC/MS), liquid chromatography/mass spectrometry (LC/MS), and nuclear magnetic resonance (NMR) spectroscopy. The cis and trans isomers of the 3‐methylfentanyl analogs were completely separated by GC/MS. Although the high temperature of the GC injection port caused thermal degradation of β‐hydroxy‐3‐methylfentanyl, the degradation was completely suppressed by trimethylsilyl derivatization. The isomers were also well separated by LC/MS on an octadecylsilyl column with 10 mM ammonium acetate and methanol as the mobile phase. The proton NMR signals were split when the hydrochloride salts of the 3‐methylfentanyl analogs were dissolved in deuterated chloroform because stereoisomers were formed by the coordination of the hydrochloride proton to the nitrogen of the piperidine ring of the 3‐methylfentanyl analogs.     

Infrared Spectra of U.S. Automobile Original Finishes (1998–2000). IX. Identification of Bismuth Oxychloride and Silver/White Mica Pearlescent Pigments Using Extended Range FT‐IR Spectroscopy,XRF Spectrometry,and SEM/EDS Analysis

Bismuth oxychloride (BiOCl) was the first viable synthetic pearl pigment developed 50 years ago. It was only used for a limited time period in automotive paint (model years 1998–2000), serving to produce luster for a single Chrysler black metallic color. Identification of this pigment in an unknown automotive paint can thus facilitate determination of the vehicle of origin. Bismuth oxychloride imparts effects similar to those produced by silver/white mica pearlescent pigments, and such a pigment was used together with bismuth oxychloride in at least one original equipment manufacturer (OEM) basecoat. Silver/white micas are now used primarily in white pearl tricoat systems. This article describes the identification of bismuth oxychloride and silver/white mica pearlescent pigments in automotive finishes using FT‐IR spectroscopy, X‐ray fluorescence (XRF) spectrometry, and SEM/EDS analysis. Data for some cadmium pigments, which were used in automotive paint several decades ago, are also presented as they produce infrared absorptions similar to that of bismuth oxychloride.