A comparison study of hair examination methodologies

A study was conducted to investigate the accuracy between two methods of hair analysis: PCR-STR DNA analysis and microscopic comparison analysis. Standard sets of pubic hairs were collected from volunteers, and unknown sets were generated from these samples. Three out of five (60%) of the hairs analyzed produced full DNA profiles that were correctly matched to the standard sets. DNA analysis was inconclusive (partial or no DNA profile) for two out of five (40%) of the samples. In contrast, the microscopic comparison analysis correctly matched four out of five (80%) of the samples to the standard sets but mis-identified one out of five (20%) of the samples. These results reinforce the practice of preliminary microscopic hair examination in narrowing down a set of hairs for DNA analysis. Microscopic comparison analysis is sufficiently reliable to remain a rapid and inexpensive method for forensic hair analysis.     

Gunshot residue particle velocity and deceleration

The velocity of over 800 gunshot residue particles from eight different sources was determined using high speed stroboscopic photography (spark gap light source). These particles were found to have an average velocity of 500 to 600 ft per second. Many particles acquired considerably higher velocities. Thus, the particles have sufficient energy to embed themselves within certain nearby targets like skin or fabric. The relatively high velocity that the particles acquire explain the formation of stippling on skin in close proximity to a muzzle discharge. These findings also indicate little influence of air currents on particle behavior near the muzzle. The deceleration of less than 100 particles during a 100-microsecond interval was also calculated. The particles experienced rapid rates of deceleration which would explain why few particles are found in test firings beyond 3 ft from the muzzle of a discharged firearm. Because of their relatively high velocity, normal wind velocity would not be expected to significantly influence their motion near the muzzle.     

Networking to support suicide survivors

This paper is the first report on a national program for increasing bereavement support for suicide survivors in the Flemish region in Belgium. A Working Group consisting of representatives of a wide variety of mental health institutions, social programs, and suicide survivor groups in the area determined that a program developing networks between the services seems to hold the greatest promise for both an increase in the number of services available and an improvement in the quality of services offered.     

Positional asphyxia: reflection on 2 cases

Positional asphyxia, a fatal condition arising because of the adoption of particular body positions, causing mechanical interference with pulmonary ventilation, can occur in various circumstances that are likely to come under the observation of the specialist in legal medicine (work, car accidents, torture, kidnapping, etc.). It is difficult to diagnose the cause of death in such cases because they generally present with an aspecific anatomopathologic picture. In some situations, positional asphyxia can be hard to distinguish from asphyxia because of chest compression. The main difference is in the way the event occurred: whether the particular position causing the asphyxia had been adopted by choice or by compulsion or necessity when an extrinsic mechanical action would result in traumatic asphyxia. The diagnosis of positional asphyxia is essentially based on 3 criteria: the body position must obstruct normal gas exchange, it must be impossible to move to another position, and other causes of natural or violent death must be excluded. To illustrate the main physiopathologic and diagnostic causes of positional asphyxia, the authors report 2 cases taken from the records of events that came under the observation of the Medico-Legal Sector of Bari University Hospital throughout the last 10 years.     

Population genetic data of eight tetrameric short tandem repeats (STRs) in Casablanca resident population to use in forensic casework

The allele frequencies for eight short tandem repeat (STR) loci HUMvWA, HUMFES/FPS, HUMF13A, HUMF13B, HUMTHO1, HUMTPOX, HUMCSF1P0, HUMLPL included in Geneprint STR kits were obtained from 234 unrelated individuals in Casablanca.     

An evaluation of the Cozart RapiScan system as an on-site screening tool for drugs of abuse in a non-conventional biological matrix: vitreous humor

The aim of this project was to evaluate the Cozart RapiScan Oral fluid Drug Testing System as an on-site screening tool for vitreous humor samples collected during post-mortem examinations. Vitreous humor is easy to collect and as it is contained within the eye it is almost completely unaffected by post-mortem redistribution. The ability to carry out an initial drug screen on vitreous humor at the earliest stage of the death investigation process could contribute significantly to the assessment of the role drugs may have played prior to confirmation with toxicological analyses at the laboratory. Vitreous humor (n = 146) was collected from autopsy examinations (111 males and 35 females) with a specific focus on cases where death occurred following a road traffic accident or where an overdose was suspected. All samples were screened using the five-panel methadone Cozart RapiScan Cartridge with an overall positive rate of 29%. Of the positive results, 43% screened positive for benzodiazepines, 17% for cocaine, 7% for methadone and 33% for opiates. Positive samples, with the exception of benzodiazepines, and 20% of negative samples were analysed by GC/MS. This is the first reported use of this system as an on-site forensic tool in death investigation and for screening for drugs of abuse in vitreous humor. The conclusions from this study show that the Cozart RapiScan System could play an important role in obtaining information on the toxicological state of the person at the time of death.     

A comparison of efficiency of manual and automatic fibres search with the Maxcan fibre finder

The aim of this work was to study the efficiency of automatic fibre searching with the Maxcan fibre finder (Cox Analytical Systems, Sweden) in comparison to manual searching. The influence of some parameters (color, thickness, background noise) on the results of a fibre search was considered. Eighteen experimental tapes with different target fibres and different background noises were prepared in the laboratory. Searching of fibres was performed manually and with the Maxcan fibre finder by different operators from four European laboratories. Two laboratories have the Maxcan fibre finder system and the two instruments were used and compared in this study. The results show that searching with the Maxcan is generally as efficient as manual searching, except for very pale or very dark fibres. Note that the tapes used for these experiments were prepared in laboratory, and are not completely representative of the tape that could be obtained in real cases. To generalize the results obtained, further research on real case samples would be necessary.