Field-portable detection of fentanyl and its analogs: A review

The need to detect fentanyl and its analogs in the field is an important capability to help prevent unintentional exposure or overdose on these substances, which may result in death. Many portable methods historically used in the field by first responders and other field users to detect and identify other chemical substances, such as hazardous materials, have been applied to the detection and identification of these synthetic opioids. This paper describes field portable spectroscopic methods used for the detection and identification of fentanyl and its analogs. The methods described are automated colorimetric tests including lateral flow assays; vibrational spectroscopy (mid-infrared and Raman); gas chromatography–mass spectrometry; ion mobility spectrometry, and high-pressure mass spectrometry. In each case the background and key details of these technologies are outlined, followed by a discussion of the application of the technology in the field. Attention is paid to the analysis of complex mixtures and limits of detection, including the required spectral databases and algorithms used to interrogate these types of samples. There is also an emphasis on providing actionable information to the (likely) non-scientist operators of these instruments in the field.     

Rapid enantiomeric analysis of zopiclone in serum by supercritical fluid chromatography–tandem mass spectrometry

Zopiclone (ZOP) is a hypnotic drug prescribed to treat insomnia. Due to the chiral nature of ZOP, the psychologically active S-form and inactive R-form need to be determined enantiomerically in a forensic drug analysis. In the present study, a supercritical fluid chromatography (SFC) method was designed with a faster analysis ability than that of previously reported techniques. The SFC–tandem mass spectrometry (SFC–MS/MS) method was optimized using a column with a chiral polysaccharide stationary phase (Trefoil CEL2). ZOP was extracted from pooled human serum using solid-phase extraction (Oasis HLB) and analyzed. The developed SFC–MS/MS method achieved the baseline separation of S-ZOP and R-ZOP within 2 min. The fit-for-purpose method validation indicated that the optimized solid-phase extraction achieved near complete recovery and approximately 70% of the matrix effect. Both the retention time and peak area showed sufficient precision. The lower and upper limits of quantification (LOQ) were 5.7 × 10⁻² ng/mL and 25 ng/mL for R-ZOP, and 5.2 × 10⁻² ng/mL and 25 ng/mL for S-ZOP. The calibration line was linear in the range from lower LOQ to upper LOQ. The stability test indicated that ZOP in serum stored in a refrigerator (4°C) degraded and about 55% remained in 31 days. The quick analysis of the SFC–MS/MS method makes it a valid option for the enantiomeric analysis of ZOP.     

The Fairness of Media Coverage in Question: An Analysis of Referendum Campaigns on Welfare State Issues in Switzerland

Abstract: The mass media are assigned an important role in political campaigns on popular votes. This article asks how the press communicates political issues to citizens during referendum campaigns, and whether some minimal criteria for successful public deliberation are met. The press coverage of all 24 ballot votes on welfare state issues from 1995 to 2004 in Switzerland is examined, distinguishing seven criteria to judge how news coverage compares to idealized notions of the media’s role in the democratic process: coverage intensity, time for public deliberation, balance in media coverage, source independence and inclusiveness, substantive coverage, and spatial homogeneity. The results of our quantitative analysis suggest that the press does fulfil these normative requirements to a reasonable extent and that fears about biased or deceitful media treatment of ballot issues are not well‐founded. However, some potential for optimizing the coverage of referendum campaigns by the Swiss press does exist.     

Differentiation of blue ballpoint pen inks by positive and negative mode LDI-MS

Usually, the differentiation of inks on questioned documents is carried out by optical methods and thin layer chromatography (TLC). Therefore, spectrometric methods were also proposed in forensic literature for the analysis of dyes. Between these techniques, laser desorption/ionization mass spectrometry (LDI-MS) has demonstrated a great versatility thanks to its sensitivity to blue ballpoint ink dyes and minimal sample destruction. Previous researches concentrated mostly on the LDI-MS positive mode and have shown that this analytical tool offers higher discrimination power than high performance TLC (HPTLC) for the differentiation of blue ballpoint inks. Although LDI-MS negative mode has already been applied in numerous forensic domains like the studies of works of art, automotive paints or rollerball pens, its potential for the discrimination of ballpoint pens was never studied before. The aim of the present paper is therefore to evaluate its potential for the discrimination of blue ballpoint inks. After optimization of the method, ink entries from 33 blue ballpoint pens were analyzed directly on paper in both positive and negative modes by LDI-MS. Several cationic and anionic ink components were identified in inks; therefore, pens were classified and compared according to their formulations. Results show that additional information provided by anionic dyes and pigments significantly increases the discrimination power of positive mode. In fact, it was demonstrated that classifications obtained by the two modes were, to some extent, complementary (i.e., inks with specific cationic dyes not necessarily contained the same anionic components).     

Examination of heterogeneous crossing sequences between toner and rollerball pen strokes by digital microscopy and 3-D laser profilometry

The determination of line crossing sequences between rollerball pens and laser printers presents difficulties that may not be overcome using traditional techniques. This research aimed to study the potential of digital microscopy and 3-D laser profilometry to determine line crossing sequences between a toner and an aqueous ink line. Different paper types, rollerball pens, and writing pressure were tested. Correct opinions of the sequence were given for all case scenarios, using both techniques. When the toner was printed before the ink, a light reflection was observed in all crossing specimens, while this was never observed in the other sequence types. The 3-D laser profilometry, more time-consuming, presented the main advantage of providing quantitative results. The findings confirm the potential of the 3-D laser profilometry and demonstrate the efficiency of digital microscopy as a new technique for determining the sequence of line crossings involving rollerball pen ink and toner.     

Drug intelligence based on MDMA tablets data: 2. Physical characteristics profiling

One of the tasks of the European project entitled “Collaborative Harmonisation of Methods for Profiling of Amphetamine Type Stimulants” (CHAMP) funded by the sixth framework programme of the European Commission was to develop a harmonised methodology for MDMA profiling and the creation of a common database in a drug intelligence perspective. Part I was dedicated to the analysis of organic impurities formed during synthesis in order to investigate traffic tendencies and highlight potential links between samples, whereas this part focuses on physical characteristics of the MDMA tablets. Diameter, thickness, weight and score were demonstrated to be reliable and relevant features in this drug intelligence perspective. Distributions of samples coming from the same post-tabletting batch (post-TB) and samples coming from different post-TB were very well discriminated by using the squared Euclidean or the Manhattan distance on standardised data. Our findings demonstrated the possibility to discriminate between MDMA samples issued from different post-TB and to find out links between samples coming from a same post-TB. Furthermore, the hypothesis that most of the MDMA samples found on the international market come from the same countries was supported.     

Radiographic age estimation based on degenerative changes of vertebrae

Age estimation is an important component of decedent identification. When assessing adult remains, anthropologists frequently use gross examination of skeletal elements, such as clavicles, ribs, and pubic symphyses. For fleshed bodies, this requires the removal of these elements and maceration prior to analysis. A new method was developed using radiographic imaging to estimate age from degenerative changes of the lower thoracic and upper lumbar vertebrae. This technique will complement anthropological age estimation methods in young and middle-aged adults and may serve as a stand-alone method for older individuals. Digital radiographs from 240 medical examiner cases were evaluated. The sample included 120 females and 120 males between the ages of 18 and 101 years. A 3-phased scoring system was used for the target vertebrae. Transition analysis was conducted on binned average scores and a Bayesian approach was used to assign age intervals. At the 90% credible interval, individuals in Bin 1 were under 36 years of age while those in Bin 3 were over 47 years of age. Individuals in Bin 2 showed too much age variation to be informative. No significant differences were found between males and females. These findings will be especially useful in the age estimation of older adults and may eliminate the need for skeletal sampling in medicolegal cases where advanced degenerative changes are radiographically observed in the lower thoracic and/or upper lumbar vertebrae. This method was developed for use on fleshed individuals but may also be applicable to skeletonized remains.