热连轧带钢生产过程中的温度场模拟

温度是热连轧带钢生产中影响产品的组织和性能重要参数,采用ANSYS有限元对热连轧生产过程的温度场进行数值模拟。模拟结果表明:高压水除鳞对带钢温度场影响相当大,高压水除鳞后,带钢端部和表面温度显著下降,带钢中心的温度基本保持不变,表面和芯部温度梯度大,除鳞后在轧件内部热传导作用下,温度梯度越来越小,最后整个轧件除端部外温度趋于均匀。     

Estimation of the post-mortem interval in beagle dogs

Estimation of the time that has elapsed between death and the post-mortem examination of a body contributes to the investigation of death by defining the period during which death may have occurred. In a veterinary context, investigations involve a range of incidents including out-of-season shooting of game animals, poaching, death during transportation and cases of neglect or non-accidental injury of domestic animals. This study on dogs of the same breed, of similar weights and held under identical conditions, shows that a combination of rectal temperature, environmental temperature, gross pathology and histological changes can provide a scientifically based estimate of the post-mortem interval during the first 10 h following death, of up to one day, one to three days, three to seven days and one to three weeks.     

不同保存条件对血中CN-浓度的影响

目的研究在各种温度贮存条件下血液中CN-浓度与保存时间的关系。方法用氯胺T衍生GC/ECD分析。结果在室温下存放的阳性血,在30天～50天中,CN-浓度有所增加,以后浓度下降很快,80天后则检不出。在4℃及-20℃下贮存的血液CN-浓度,在一定的时间段中,有所增加,以后则逐渐下降,至8个月仍可检出CN-。结论不同条件下存放的血液CN-其浓度的变化是不同的。     

Estimation of Time of Death With a Fourier Series Unsteady‐State Heat Transfer Model

Abstract: The purpose of this study was to return to fundamental principles of heat transfer and derive a suitable model to establish a firm basis for constructing a postmortem human cooling curve. A Fourier Series Model was successfully applied to unsteady heat transfer within a wooden cylinder in controlled laboratory conditions. Wood has similar thermal diffusivity properties as human tissue. By manipulation of the model, sensitivity analyses were performed to observe the impact of changes in values of input variables. Variables of initial temperature of the cylinder and ambient surrounding temperature were shown to be very sensitive and have the most impact upon predictive results of the model. The model was also used to demonstrate the existence of an initial temperature plateau, which is often the subject of controversy in estimating time of death. Finally, it was demonstrated how the Fourier Series Model can be applied to estimate time of death for humans.     

Effect of Investigator Disturbance in Experimental Forensic Entomology: Carcass Biomass Loss and Temperature

Abstract: Often carrion decomposition studies are conducted using a single carcass or a few carcasses sampled repeatedly through time to reveal trends in succession community composition. Measurements of biomass and other abiotic parameters (e.g., temperature) are often collected on the same carcasses but are rarely a focal point of the studies. This study investigated the effects that repeated sampling during experiments have on the decomposition of carrion, measured as both gross biomass (carcass plus fauna) and net biomass (carcass only), on carcasses disturbed on every visit (with weighing only or also with the collection of fauna) and on carcasses disturbed only once. Each trial lasted at least 21 days, with samples taken in triplicate. Rat carcasses used in this study were placed in the field on the same day and either weighed on every visit or ignored until a given day. Internal and ambient air temperatures were recorded on each carcass at the time of sampling and on undisturbed carcasses using temperature loggers. The presence of succession fauna did not result in significant biomass loss on most days; however, there were individual days early in decomposition (days 3 through 6) when the succession fauna comprised a large portion of the gross biomass. With the exception of biomass loss by the emigration of maggots on days 4 and 5, neither repeated weighing of the carcasses nor repeated weighing and faunal sampling of the carcasses statistically affected the rate of biomass loss. Internal temperatures of carcasses sampled repeatedly were frequently 2–5°C lower than those that had not been disturbed, and ambient temperatures differed significantly depending on the location of measurement device. Results indicate that methods used historically for biomass loss determination in experimental forensic entomology studies are adequate, but further refinements to experimental methodology are desirable.     

Factors affecting the forensic examination of automotive lubricating oils

Lubricating oil comparisons impact a variety of forensic investigations, including cases where oil was transferred from a suspect vehicle to the crime scene or victim. In this study, high-temperature gas chromatography/mass spectrometry was used to examine the influence of oil mixtures and oil changes over time on the comparison of known and questioned lubricating oils. Varying concentrations of oil mixtures were prepared and showed the potential for identifying individual components. Motor oils from 18 automobiles monitored over a 2-month period did not demonstrate significant changes in the chromatographic data. Chemometric analysis of motor oil mass spectral data provided little information regarding differentiation of, or changes in, the samples. Power steering fluid (PSF) from a naturally occurring leak collected from several locations was consistent with the PSF in the automobile's reservoir, and the PSF composition did not change over time.     

不同温度下大鼠脑组织RNA降解与早期PMI的相关性

目的探讨大鼠脑组织8种RNA指标,在不同温度下的表达水平与早期死亡时间(PMI)的相关性。方法将222只SD大鼠随机分为对照组(死后0 h)和4个实验组,实验组断颈处死后分别置于5℃、15℃、25℃和35℃的环境中,于死后1~24 h内9个时间点提取脑组织RNA,利用实时荧光定量PCR技术检测8种RNA指标(β-actin、GAPDH、RPS29、18S rRNA、5S rRNA、U6 snRNA、miRNA-9及mi RNA-125b)的表达水平,ge Norm软件选取合适内参,SPSS软件对内参标准化RNA指标进行回归分析,R软件构建推断PMI的数学模型,另选6只已知PMI的SD大鼠予以验证。结果 5S rRNA、miR-9和mi R-125b表达稳定,可作为内参指标。β-actin和GAPDH具有良好的时序性降解规律,在24 h内随PMI延长不断降解。R软件拟合得ΔCt值随PMI和温度变化的数学模型可用以推断PMI。运用β-actin和GAPDH验证模型的平均误差率分别为14.1%和22.2%。结论β-actin和GAPDH表达水平与PMI和环境温度相关性良好。本研究建立的数学模型可为温度变化条件下的早期PMI推断提供参考。     

Validation of a new method of providing case-specific time-of-death estimates using cadaver temperatures

The near ubiquitous presence of numerical simulation has made case-specific calculations of body temperatures following death possible so that accurate calculations of body temperatures can provide valuable information for estimating the time of death and can aid in forensic investigations. Here, a computational approach is described that has been validated against multiple, independent, and experimental investigations. The approach only requires one subjective input parameter (the heat transfer coefficient). A simple algorithm serves as a guidepost to the selection of this parameter. The algorithm incorporates clothing and the space in which the body is housed. Heat transfer coefficients that range from h = 2 W/m²/°C for bodies that are heavily clothed to h = 9 W/m²/°C for bodies that are nude (in air). The method also requires setting of ambient temperature conditions (ambient temperature)—however, that input is often available. The paucity of inputs makes this technique remarkably easy to employ. The new method is also able to calculate cadaver cooling rates for situations where the cadaver is in a timewise or spatially changing thermal environment (diurnal temperature variations, bodies partially submerged in water, changes to weather, insolation, etc.). Results from the present calculations are compared with a large body of measurements from the literature; it was found that the predictions and measurements were in excellent agreement, regardless of the ambient temperature conditions and the nature of the clothing of the body. This new calculation approach can be used with reasonable accuracy for determining cadaver cooling and time since death.     

Effects of Re‐heating Tissue Samples to Core Body Temperature on High‐Velocity Ballistic Projectile–tissue Interactions

Damage produced by high‐speed projectiles on organic tissue will depend on the physical properties of the tissues. Conditioning organic tissue samples to human core body temperature (37°C) prior to conducting ballistic experiments enables their behavior to closely mimic that of living tissues. To minimize autolytic changes after death, the tissues are refrigerated soon after their removal from the body and re‐heated to 37°C prior to testing. This research investigates whether heating 50‐mm‐cube samples of porcine liver, kidney, and heart to 37°C for varying durations (maximum 7 h) can affect the penetration response of a high‐speed, steel sphere projectile. Longer conditioning times for heart and liver resulted in a slight loss of velocity/energy of the projectile, but the reverse effect occurred for the kidney. Possible reasons for these trends include autolytic changes causing softening (heart and liver) and dehydration causing an increase in density (kidney).     

基于DS18B20设计的多点测温系统

多点温度测量系统在工程项目中应用越来越广泛.文中介绍了基于DS18B20数字温度传感器设计的10点测温系统、DS18B20的基本特性、系统硬件电路的连接及软件的设计流程.